CIP Explicit (Gen1)

note this driver is available for litmus edge version 3 3 1 and later review the following information for setting up and configuring the cip explicit (gen1) driver litmus edge compatible series compatibility parameter compatible items driver type ethernet validated devices/series devices that support the https //www odva org/technology standards/key technologies/ethernet ip/ when configuring tags for this driver, you must enter the case sensitive register name exactly as it is defined in the plc see the free tags section below to learn more to set up and configure this device in litmus edge, you will need to do the following step 1 set up and configure the plc device step 2 set up the plc device in litmus edge devicehub step 3 configure the list of registers step 1 set up and configure the plc device if the device is configured for ethernet access, find its network parameters otherwise, use software on your computer to configure the device for ethernet access step 2 set up the plc device in litmus edge devicehub configure the following parameters when you docid\ pal6abpzbrimdu9lvgj30 with this driver update default values to the specific setup of your device parameter value type odva driver cip explicit (gen1) network address the device address you defined in step 1 network port 44818 step 3 configure the list of registers when you docid 8se7z3pmrfwl1nmzcwalx to the connected device, refer to the following tag parameters and available value types refer to the following additional resources docid 583p fbuozem6whgrdgkq docid\ ifbwcou90qtfodk hrysr free tags this driver doesn't have a list of available register names in the devicehub add tag form to add tags, you must enter the case sensitive register name exactly as it is defined in the plc a connected status for the device won't display until a tag with a correct register name is created available value types bool byte byteinarray sint sintinarray usint usintinarray word int uint uintinarray dword udint udintinarray