VIPA 300s Ethernet (Gen1.3)

review the following information for setting up and configuring the vipa 300s ethernet (gen1 3) driver litmus edge compatible series compatibility parameter compatible items driver type ethernet validated devices/series vipa 300s plc series https //www vipa com/en/products/control systems/300s/ to set up and configure this device in litmus edge, you will need to do the following step 1 set up and configure the plc device step 2 set up the plc device in litmus edge devicehub step 3 configure the list of registers step 1 set up and configure the plc device if the device is configured for ethernet access, find its network parameters otherwise, follow the steps below to configure your device note down the following information and refer to it when needed device vipa cpu 315 4ne12 communication i/f ethernet refer to the following figure launch primary setting tool and set up set pg/pc interface to use the network adapter browse the devices in the subnet and set up the network parameters for the device, and then download into the device launch simatic manager and configure hw config from the project, select cpu318 2 dp as the cpu module with two cp 343 1 modules in netpro, set up set pg/pc interface and use the adapter in the same subnet with the device double click the module icon and set up the network parameters download the setting into the device open the ob1 block and make connection with the device step 2 set up the plc device in litmus edge devicehub parameter value type vipa driver vipa 300s ethernet (gen1 3) network address the device address you defined in step 1 port 102 slot number 1 name value type address format min address max address i bit, byte, char, word, int, dword, dint, real, string ddddd 0 40957 q bit, byte, char, word, int, dword, dint, real, string ddddd 0 40957 m bit, byte, char, word, int, dword, dint, real, string ddddd 0 40957 db bit, byte, char, word, int, dword, dint, real, string dddddd 0 327677