Yokogawa FA-M3 Ethernet (Gen1.3)

review the following information for setting up and configuring the yokogawa fa m3 ethernet (gen1 3) driver litmus edge compatible series compatibility parameter compatible items driver type ethernet validated devices/series yokogawa fa m3 series https //www yokogawa com/us/solutions/products and services/control/control devices/programmable logic controllers plc pac/fa m3/ to set up and configure this device in litmus edge, you will need to do the following step 1 set up and configure the plc device step 2 set up the plc device in litmus edge devicehub step 3 configure the list of registers step 1 set up and configure the plc device if the device is configured for ethernet access, find its network parameters otherwise, follow the steps below to configure your device record the following information and refer to it when needed device yokogawa fa m3 f3sp25 sn communication i/f ethernet refer to the following figure launch widefield3 v3 02 software and create a project with the device model click tools > set up environment configure the network parameters click online > connect and verify the connection is successful step 2 set up the plc device in litmus edge devicehub parameter value type yokogawa driver yokogawa fa m3 ethernet (gen1 3) network address the device address you defined in step 1 port 12289 station id 1 step 3 configure the list of registers when you add tags docid\ xgwokqbtpevii7or82ll0 to the connected device, use the following tag/register mapping table name value type address format min address max address description x bit ddddd 0 71644 input bit y bit ddddd 0 71644 output bit i bit ddddd 1 65535 m bit dddd 1 9984 l bit ddddd 0 78192 f word dddddd 1 524288 z word dddd 1 1024 w word ddddd 1 78192 v word ddd 1 256 b word dddddd 1 262144 d word ddddd 1 65535